Component Location Overview - Passenger Occupant Detection System
WARNING:
The replacement part (service kit) for the passenger occupant detection system is already precalibrated and must not be separated under any circumstances. The service kit consists of:
- Passive Occupant Detection System Control Module - J706
- Passive Occupant Detection System Pressure Sensor - G452
- Passenger Occupant Detection System Mat
- Seat Cushion
- Wiring Harness between Passive Occupant Detection System Control Module -J706 and Passive Occupant Detection System Pressure Sensor -G452.
WARNING:
Follow all safety precautions when working on the passenger occupant detection system. Refer to ADDITIONAL SAFETY PRECAUTIONS - PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION, MARKET-SPECIFIC .
NOTE:
The passenger occupant detection system is only installed in the front passenger seat.
- Passenger Occupant Detection System Pressure Sensor -G452-
- Component of the passenger occupant detection system mat -item 6-
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .CAUTION:
Do not disconnect the connector.
- Seat Pan
- Clip
- Cushion
- For the seat pan
- Do not separate from the passenger occupant detection system mat -6-
- Clip
- Do not release.
- Mat
- For the passenger occupant detection system
- Component with the Passenger Occupant Detection System Pressure Sensor -G452-
- Do not disconnect from the seat pan cushion -4-
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Mount
- The version depends on the model
- For the Passenger Occupant Detection System Control Module -J706-
- Expanding Pin
- For securing the mount to the seat pan
- Wiring Harness
- Do not separate from the Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-
- Front Passenger Seat Position Sensor -G554-
- This is a wiring harness component -9-
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING, EQUIPMENT WITH PASSENGER OCCUPANT DETECTION SYSTEM FOR FRONT PASSENGER AIRBAG DEACTIVATION .
- Passenger Occupant Detection System Control Module -J706-
- The version depends on the model
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .CAUTION:
Do not disconnect the connector.
- Bolt
- 1.5 Nm