Airbag Control Module -J234-, Removing And Installing: Installing
- Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
Install in reverse order of removal and Note The Following:
Make sure the connectors are installed all the way and engage audibly.
The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.
-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY .
If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.
The Airbag Control Module -J234- must be coded after replacing it using the Vehicle Diagnostic Tester.
The Airbag Control Module -J234- ground connection is achieved via the housing with the body.