Tighten The Bolts In The Steps Shown In The Sequence:

WARNING: This page is about a different variant/trim than selected.

-- Tighten The Bolts In The Steps Shown In The Sequence:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 to 15-	Install by hand all the way
2.	-1 to 15-	8 Nm
3.	-1, 2, 4, 5- and -7 to 15-	45° additional turn
4.	-3 and 6-	After installation of the vibration damper a 45° additional turn

Fig 1: Tightening Sequence Timing Chain

Courtesy of AUDI OF AMERICA, LLC

Replace The Bolts That Were Tightened With An Additional Turn After Removing Them.

-- Tighten The Bolts In The Steps Shown In The Sequence:

Step	Bolts	Tightening Specification/Additional Turn
1.	-1 to 8-	Install by hand all the way
2.	-1 to 8-	8 Nm
3.	-2 and 3- and -5 to 8-	45° additional turn
4.	-1 and 4-	After Installation Of The Vibration Damper A 45° Additional Turn