Tightening Specifications

WARNING: This page is about a different variant/trim than selected.

-- Tighten The Bolts In The Steps Shown In The Sequence:

Fig 1: Tightening Sequence For Cylinder Head Bolts

Courtesy of AUDI OF AMERICA, LLC

Step	Bolts	Tightening specification/additional turn
1.	-1 through 10-	Install by hand all the way
2.	-1 through 10-	"Without collar" 40 Nm "with collar" 50 Nm, difference. Refer To OVERVIEW - CYLINDER HEAD .
3.	-1 through 10-	90° additional turn
4.	-1 through 10-	90° additional turn
5.	-arrows-	8 Nm
6.	-arrows-	90° additional turn

Fig 2: Checking For Distortion

Courtesy of AUDI OF AMERICA, LLC

-- Check The Cylinder Head In Several Places For Distortion Using A Straight Edge And A Feeler Gauge.

Fig 3: Tightening Sequence For Oil Separator

Courtesy of AUDI OF AMERICA, LLC