Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
- Replace The Bolts That Were Tightened With An Additional Turn After Removing Them.
-- Tighten The Bolts In The Steps Shown In The Sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 7- | Install by hand all the way |
| 2. | -1 to 6- | 9 Nm |
| 3. | -7- | M6: Pretension To 8 Nm M8: Pretension To 20 Nm |
| 4. | -7- | 90° additional turn |
- Both Surfaces -arrows- Must Align.