Overview - Balance Shaft Drive Chain: Notes
WARNING: This page is about a different variant/trim than selected.
- Guide Pin
- 20 Nm
- Guide Rail
- For The Timing Chain
- Balance Shaft Drive Chain
- Removing And Installing. Refer To BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING
- Guide Pin
- 20 Nm
- Tensioning Rail
- For The Drive Chain For The Balance Shafts
- Balance Shaft
- Must be replaced after removing
- Exhaust Side
- Lubricate The Bearing With Engine Oil
- Replacing. Refer To BALANCE SHAFT, REMOVING AND INSTALLING, EXHAUST SIDE .
- Guide Pin
- 20 Nm
- Guide Rail
- For The Timing Chain
- Chain Tensioner
- 85 Nm
- Coat The Seal With Sealant
- Three Stage Chain Sprocket
- Installation position. Refer To The Appropriate Service Information. .
- O-ring
- Lubricate With Engine Oil
- Mounting Pin
- Lubricate With Engine Oil
- Installation position. Refer To The Appropriate Service Information. .
- Intermediate Sprocket
- The intermediate sprocket must be replaced if the bolt -item ) OVERVIEW - BALANCE SHAFT DRIVE CHAIN Is Loosened.
- Washer
- Bolt
- Tightening sequence. Refer To The Appropriate Service Information (BEARING BRACKET, REMOVING AND INSTALLING ). .
- Always Replace After Removing
- The intermediate sprocket -item ) OVERVIEW - BALANCE SHAFT DRIVE CHAIN must be replaced if the bolt is loosened.
- Replace And Lubricate The O-Ring -1- After Removal.
- The Alignment Pin -arrow- For The Bearing Pins Must Engage In The Hole In The Cylinder Block.
- Lubricate The Bearing Pins
CAUTION:
There Is a Risk of Destroying the Engine When the Intermediate Sprocket Is Missing Backlash.
The New Intermediate Sprocket Has An Anti-Friction Coating That Wears Off After A Short Period Of Use, Which Automatically Adjusts The Backlash.
- Never Reuse The Intermediate Sprocket.