Transmission Side Sealing Flange, Removing And Installing, Oil Side Sealing Lip: Installing
- Replace the sealing flange after removal.
To prevent contamination of the lubricating system with sealant residue, place a clean cloth over the open part of the oil pan.
- Wear protective eyewear.
-- Remove any remaining sealant from the cylinder block -1- using, for example, a rotating plastic brush.
-- Clean any oil and grease off of the sealing surfaces and crankshaft journal.
TIP:
Be sure to check the expiration date of the sealant.
-- Cut the tube nozzle at the front marking (nozzle diameter: approximately 2 mm).
- Do not apply sealant bead thicker than indicated.
- Sealant bead thickness: 2 to 3 mm.
- The sealing flange must be installed within five minutes of applying the sealant.
- The sealing lip must be pointed to the engine after installing. If the sealing lip >>folds<< outward when installing, leaks will result.
-- Check the :T10122/6A -B- ; it must not be tilted or contaminated.
-- Mount the :T10122/1 -A- on the :T10122/6A -B- in direction of -arrow-.
-- Slide the Sealing Flange -- -C- on the Guide Piece -B-, with the outer side on it in direction of -arrow-.
-- Remove Guide Piece -A-.
-- Place the Guide Piece -A- with the Sealing Flange -- -B- on the crankshaft journal.
TIP:
It is not necessary to tighten the bolts -arrows-
-- Slide the Sealing Flange -- -B- through the Guide Piece -A- on the crankshaft journal.
-- Remove the Guide Piece -A-.
-- Tighten the sealing flange.
- After installing the sealing flange, the sealant must harden for approximately 30 minutes. Only afterward may the engine oil be replenished.
Further installation is performed in reverse order of removal, while noting the following:
-- Install the intermediate plate. Refer to appropriate service information. .
-- Install the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
-- Check the oil level. Refer to ENGINE OIL .