Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
- Replace the bolts that were tightened with an additional turn after removing them.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1 to 6- | Install by hand all the way |
| 2. | -1 to 6- | Aluminum bolts: 4 Nm Steel bolts: 9 Nm |
| 3. | -1 to 6- | Aluminum bolts: 45° additional turn |
TIP:
Only six bolts are installed, two bolt openings remain open.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specifications |
|---|---|---|
| 1. | -1 to 8- | Install by hand all the way |
| 2. | -1 to 8- | 9 Nm |
-- Hang the intermediate plate on the sealing flange -arrow upper- and slide it on the alignment sleeves -arrows lower-.