Vibration Damper, Removing And Installing: Notes
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Counterhold - Vibration Damper :T10355
- Vibration Damper Assembly Tool :T10531
- Wrench - 21mm :T40263
- Adapter :T40314
- 24 mm Socket
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview and parts information prior to starting procedure.
Mandatory Replacement Parts
- Bolts - Vibration Damper
Individual Components of the :T10531 :
- Vibration Damper Assembly Tool - Counterhold Tool :T10531/1
- Vibration Damper Assembly Tool - Tensioning Pins :T10531/2
- Vibration Damper Assembly Tool - Turning Over Tool :T10531/3
- Vibration Damper Assembly Tool - Knurled Nut :T10531/4
- The vibration damper bolt -A- connects the vibration damper -1-, the timing chain sprocket -2- and the crankshaft -3- with each other. Before removing the bolt, the chain sprocket must be secured to the crankshaft as described in the following.