Sub-Assembly Bracket, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
- Replace the bolts that were tightened with an additional turn after removing them.
- Replace the O-ring and seals after removing.
- Used coolant cannot be used again.
-- Coat the new O-rings -4- with coolant additive.
-- Insert the connection -2- into the coolant pump housing -3-.
-- Slide the sub-assembly bracket -1- onto the connection and then install and tighten the bolts.
-- Install the oil filter. Refer to ENGINE OIL .
There are additional procedures depending on the model. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .