Overview - Cylinder Block, Belt Pulley Side, Vehicles With Electro-Mechanical Power Steering: Notes

Fig 1: Cylinder Block, Belt Pulley Side, Vehicles With Electro-Mechanical Power Steering Exploded View

Courtesy of AUDI OF AMERICA, LLC

1. Ribbed Belt
   • Check for wear
   • Do not kink
   • Before removing, mark the running direction using chalk or a felt-tip pen.
   • Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING, VEHICLES WITH ELECTRO-MECHANICAL POWER STEERING 
   • Ribbed belt routing. Refer to appropriate service information. .
   • When installing, make sure it is seated correctly on the belt pulleys
2. Ribbed Belt Tensioner
   • To release tension on ribbed belt, pivot using a wrench.
   • Secure using the Locking Pin :T10060A 
   • Removing and installing. Refer to RIBBED BELT TENSIONING DAMPER, REMOVING AND INSTALLING, VEHICLES WITH ELECTRO-MECHANICAL POWER STEERING 
3. Bolt
   • 8 Nm + 45°
   • Always replace after removing
4. Bolt
   • 150 Nm + 90°
   • Always replace after removing
   • Use the Counterhold - Vibration Damper :T10355  to loosen and tighten
   • Coat the O-ring with engine oil
5. O-ring
   • Not a replacement part; supplied with the bolt -item 4-  OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE, VEHICLES WITH ELECTRO-MECHANICAL POWER STEERING
6. Vibration Damper
   • With the ribbed belt pulley
   • Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING 
7. Sub-Assembly Bracket
   • With oil filter and engine oil cooler
   • Removing and installing the sub-assembly bracket. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
   • Removing and installing the engine oil cooler. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
8. Seal
   • Always replace after removing
9. Bolt
   • Tightening specification and sequence. Refer to appropriate service information. .
10. Bolt
    • Tightening specification. Refer to GENERATOR .
11. Generator
    • Removing and installing. Refer to GENERATOR .
12. Alignment Sleeves
    • For the A/C compressor
13. A/C Compressor
    • Do not remove or disconnect the refrigerant lines
    • Removing and installing. Refer to A/C COMPRESSOR .
14. Bolt
    • Tightening specification. Refer to A/C COMPRESSOR .

Courtesy of AUDI OF AMERICA, LLC

1. Vibration Damper
2. Ribbed Belt Tensioner
3. Generator
4. A/C Compressor