Overview - Cylinder Block, Belt Pulley Side, Hybrid Vehicles
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 150 Nm + 90°
- Always replace after removing
- Lubricate the O-ring
- O-ring
- Not a replacement part; supplied with the bolt
- Vibration Damper
- With the ribbed belt pulley
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING
- Sub-Assembly Bracket
- With oil filter and engine oil cooler
- Removing and installing the sub-assembly bracket. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
- Removing and installing the engine oil cooler. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- Bolts
- Always replace after removing
- Tightening specification and sequence. Refer to .
- Electrical A/C Compressor -V470-
- Removing and installing. Refer to A/C COMPRESSOR .
- Electrical A/C Compressor -V470- Bolts
- There are different bolt lengths.
- Tightening specification. Refer to A/C COMPRESSOR .
- Replace the bolts that were tightened with an additional turn after removing them.
-- Mount the sub-assembly bracket and then install the bolts -4- first.
-- Tighten the bolts in the steps shown in the sequence:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 5- | Install by hand all the way |
| 2. | -1 through 5- | 20 Nm |
| 3. | -1 through 5- | 90° additional turn |