Sensor Wheel, Removing And Installing: Installing
WARNING: This page is about a different variant/trim than selected.
Install in reverse order of removal and note the following:
-- Always replace the sensor wheel -2- each time the bolts -1- are loosened.
TIP:
After tightening a second time, the attachment point of the countersunk bolts in the sensor wheel is so deformed that the bolt heads are at the crankshaft -3- -arrows- and the sensor wheel is loose under the bolts.
- Installation of sensor wheel is only possible in one position - the bores are offset.
-- Install the balance shaft timing chain. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- If the sensor wheel was replaced, perform an "adaptation". Refer to Vehicle Diagnostic Tester in Guided Functions .