Crankshaft, Measuring Axial Clearance
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Dial Indicator Holder :VW387
- Dial Gauge - 0-10mm :VAS6079
-- Attach the :VAS6079 with the :VW387 to the cylinder block and set indicator against crankshaft counterweight.
-- Press the crankshaft against the dial gauge by hand and set the dial gauge to "0".
-- Press the crankshaft off the dial gauge and read the measurement.
Axial clearance:
- New: 0.070 to 0.231 mm.
- Wear limit: 0.30 mm.