Overview - Balance Shaft
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 9 Nm
- Always replace after removing
- Balance Shaft
- Always replace after removing
- Intake side
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, INTAKE SIDE .
- Balance Shaft
- Always replace after removing
- Exhaust side
- Lubricate the bearing with engine oil
- Replacing. Refer to BALANCE SHAFT, REMOVING AND INSTALLING, EXHAUST SIDE .
- Bolt
- 9 Nm
- Always replace after removing
- Balance Shaft Pipe
- Installation position. Refer to appropriate service information. .
- Exhaust Side Balance Shaft Seal
- Replacing. Refer to BALANCE SHAFT GASKET, REPLACING, INTAKE SIDE .
- The pin from the balance shaft pipe must fit into the groove -arrow-.