Part III

Part I.  Refer To OVERVIEW - TURBOCHARGER .

Part II.  Refer To OVERVIEW - TURBOCHARGER .

Part IV  - 1.8L Engine Only. Refer To OVERVIEW - TURBOCHARGER .

Courtesy of AUDI OF AMERICA, LLC

1. Gasket
   • Always replace after removing
2. Nut
   • Tightening Sequence. Refer To TIGHTENING SPECIFICATION AND SEQUENCE  .
   • Always replace after removing
   • Coat the exhaust manifold stud bolts with hot bolt paste. Refer To the Parts information for the hot bolt paste.
3. Bolt
   • 35 Nm 
4. O-ring
   • Always replace after removing
5. Coolant Return Line
6. Bolt
   • 9 Nm 
7. Turbocharger
   • Can only be replaced with exhaust manifold and vacuum diaphragm.
   • Removing and installing. Refer To TURBOCHARGER, REMOVING AND INSTALLING 
8. Bolt
   • 30 Nm 
9. Bracket
10. Support
11. Bolt
    • 30 Nm 
12. Bolt
    • 30 Nm 
    • Coat The Bolt With Hot Bolt Paste. Refer To The Parts Information For The Hot Bolt Paste.
13. Nut
    • 30 Nm 
    • Always Replace After Removing
    • Do Not Open When Removing The Turbocharger
    • Coat The Exhaust Manifold Stud Bolts With Hot Bolt Paste. Refer To The Parts Information For The Hot Bolt Paste.
14. Clamping Strip