Overview - Charge Air Hose Connections: Installing
WARNING: This page is about a different variant/trim than selected.
-- If The Seal Is Replaced, Place It In The Groove On The Air Duct Hose.
- The Seal Must Sit In The Groove All The Way Around And Must Not Be Twisted.
-- Lubricate The Sealing Surfaces And The Seal.
-- Bring The Clip Into The Release Position -1-.
-- Slide The Air Duct Pipe Into The Connector All The Way.
-- Bring The Clip Into The Locked Position -2- And Press The Air Duct Pipe Back.
-- Check For Correct Seating And Proper Locking Of The Connector Coupling By Pulling On The Air Duct Pipe.