Oil Pan Lower Section, Removing And Installing: Removing
WARNING: This page is about a different variant/trim than selected.
- Engine oil drained. Refer to ENGINE OIL .
Depending on the model, preliminary work may be required. Refer to appropriate service information. .
-- Disconnect the connector from the Oil Level Thermal Sensor -G266- -arrow-.
-- Remove the bolts -1 through 19-.
-- Remove the oil pan, if necessary loosen by applying light strikes with a rubber hammer.
-- If the oil pan lower section is replaced, remove the Oil Level Thermal Sensor -G266-. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .