Overview - Flywheel And Dual Clutch
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 Audi S4, 2015 Audi S4, 2014 Audi S4, 2013 Audi S4, and 2012 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All assembly work and tightening specifications are outlined in the "7 Speed S tronic Transmission 0B5, Servicing, (S tronic)" repair information.
- Flywheel
- There are different versions depending on the date of manufacture.
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING .
- Clutch Cover
- There are different versions depending on the date of manufacture, with or without a thrust washer (refer to -item 7- Thrust Washer, see Fig 1)
- Removing and installing. Refer to FLYWHEEL, REMOVING AND INSTALLING , and DUAL CLUTCH, INSTALLING .
- Bolt
- Tightening specification. 22 Nm + 90° additional turn .
- O-Ring
- Replace
- Dual Clutch
- There are different versions depending on the date of manufacture.
- Remove. Refer to DSG CLUTCH, REMOVING .
- Installing. Refer to DUAL CLUTCH, INSTALLING
.
- Always perform the necessary "Guided Functions " on the Vehicle Diagnostic Tester after replacing the dual clutch. Refer to TRANSMISSION GUIDED FUNCTIONS .
- Transmission Housing
- Thrust Washer
- Depending on the date of manufacture, clutch cover allocation.
- Ball Bearing
- For the input shaft
- Replacing. Refer to INPUT SHAFT .
- Locking Ring
- For ball bearing
- Replace
- Locking Ring
- For the dual clutch
- Replace
- Shaft Seal
- For the input shaft
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
- Bolt
- Tightening specification. Refer to OVERVIEW - FLYWHEEL AND DUAL CLUTCH - item 12- "Bolt" .