LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A5 2.0T >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Assembly [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] (Cabriolet) >> 10 Engine Assembly >> SUBFRAME Mount >> Overview - SUBFRAME Mount

Overview - SUBFRAME Mount

Fig 1: Exploded View Of Engine Mount
GWWA10-11044Courtesy of AUDI OF AMERICA, LLC
  1. Not Installed
  2. Bolt
    • 20 Nm
  3. Retaining Plate
    • For the engine mount
    • If the engine mount is faulty, replace the retaining plate
    • Check the retaining plate on the opposite side; replace if necessary
  4. Bracket
    • For the hydraulic line
    • Only for vehicles with hydraulic power steering
  5. Nut
    • 9 Nm
  6. Bolt
    • 40 Nm
  7. Engine Support
  8. Bolt
    • 10 Nm
  9. Heat Shield
  10. Bolt
    • 90 Nm +90° additional turn
    • Always replace
  11. Engine Mount
    • Left only with Left Electrohydraulic Engine Mount Solenoid Valve -N144- depending on equipment and version
    • Also right with Right Electrohydraulic Engine Mount Solenoid Valve - N145- depending on equipment and version
    • Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
    • Depending on the version replace in pairs.
  12. Subframe
  13. Bolt
    • 55 Nm
scientia non olet · About LEMON Manuals