LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2012 >> A5 2.0T >> Repair and Diagnosis >> Engine Mechanical >> Exhaust >> Exhaust System, Emission Controls [CABB, CABA, CABD, CAEA, CAEB, CDHB, CDNB, CDNC, CDHA, CDZA, CADA, CCUA, CFKA, CPMA, CAED, CPMB] (Cabriolet) >> 26 Exhaust System, Emission Controls >> Exhaust Pipes/Mufflers >> Front Exhaust Pipe, Removing And Installing >> Removing

Front Exhaust Pipe, Removing And Installing: Removing

Fig 1: Identifying Nuts -Arrows-
GWWA26-11208Courtesy of AUDI OF AMERICA, LLC

-- Remove the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

-- Remove the nuts -arrows-.

Fig 2: Clamping Sleeve Threaded Connections
GWWA26-10538Courtesy of AUDI OF AMERICA, LLC
CAUTION:

Risk Of Damaging The Coupling.

  • Coupling must not be bent more than 10°.
  • Do not load the coupling on the cable.
  • Do not damage the wire mesh on the coupling.

-- Loosen the threaded connections -arrows-, slide the clamping sleeve to the rear and remove the front exhaust pipe/front muffler.

scientia non olet · About LEMON Manuals