After-Run Coolant Pump -V51-, Removing And Installing, Version 1: Removing

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Loosen the hose clamps -arrows- and remove the air duct hose.

Fig 1: Air Intake Hose Components

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -5-.

Fig 2: Removing And Installing After-Run Coolant Pump -V51- (Non-Hybrid Vehicles With Engine Code CDZA)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -4- free up the Ground Wire, and then remove the double bolt.

-- Remove the nut -2-.

-- Loosen the hose clamps -3-, then clamp off the coolant hoses with the :3094  and then remove them.

-- Remove the bolts -1- and the After-Run Coolant Pump -V51-.