Brake Caliper, Removing And Installing, 1LA, 1LB, 1LJ And 1LD 1ZT + S4 /S5: Installing

NOTE:

Clean Bolts Before Reusing

Replace Damaged Bolts

Always replace self-locking bolts.

-- Carefully press the brake caliper with the brake carrier and the installed brake pads over the brake rotor.

-- Tighten the brake carrier with bolts -1-.

Fig 1: Free Up Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Insert the brake hose in the bracket -4-.

-- Insert the wire in the bracket -2- and lock it to the right -B-.

-- Install The Wheels.

Wheel bolt tightening specification. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower The Vehicle.