Tunnel CROSSMEMBER

WARNING: This page is about a different variant/trim than selected.

Special tools and workshop equipment required

Removing

-- Remove the rear noise insulation -2-. Refer to Removal and Installation .

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Install the T10337 on the V.A.G 1383 A.

Fig 2: Mounting T10337 On V.A.G 1383 A And Attach It To Bottom Of Transmission

Courtesy of AUDI OF AMERICA, LLC

-- Position the T10337 on the bottom of the transmission.

-- Lift the transmission slightly using the V.A.G 1383 A.

WARNING:

There is the risk of an accident.

The V.A.G 1383 A may only be used during assembly and must not sit unsupervised under the vehicle.

-- Remove the bolts from the tunnel crossmember -arrows-.

Fig 3: Identifying Crossmember & Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrow- and the tunnel crossmember.

Fig 4: Identifying Nuts And Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

Installing

Install in reverse order, paying attention to the following:

-- Install the rear noise insulation. Refer to Removal and Installation .