Brake Booster Pressure Sensor -G294-: Removing

-- Remove the plenum chamber cover, refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

NOTE:

The brake booster pressure sensor -- is located in the plenum chamber near the brake booster.

-- Disconnect electrical connector -1-.

-- Remove pressure sensor in -direction of arrow-.

Fig 1: Identifying Pressure Sensor

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The pressure sensor is secured with clips.

-- Release clips with pliers -1-.

Fig 2: Identifying Brake Booster Pressure Sensor G294, Clips And Pliers

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pry the brake booster pressure sensor -- off.