Electronic Parking Brake Rear Caliper
NOTE:
When servicing, install entire repair kit.
Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals.
- 1 -
Self-Locking Bolt
- 35 Nm
- Always replace.
- Counterhold at the guide pin when loosening and tightening.
- 2 -
Brake Caliper Housing With Actuator
- 3 -
Bleeder Valve
- 10 Nm
- 4 -
Dust Cap
- Push onto bleed valve.
- 5 -
Seal
- Removing and installing, refer to REAR BRAKE CALIPER PISTON .
- 6 -
Pressure Nut
- To operate parking brake.
- 7 -
Pistons
- Removing and Installing, refer to REAR BRAKE CALIPER PISTON .
- 8 -
Guide Pins
- Grease before pulling on protective cap.
- Delivered as a replacement part with sufficient grease.
- Replacing, refer to REAR BRAKES GUIDE PINS AND PROTECTIVE CAPS .
- 9 -
Cap
- Pull onto the brake carrier and guide pin.
- Replacing, refer to REAR BRAKES GUIDE PINS AND PROTECTIVE CAPS
- 10 -
Brake Carrier with Guide Pins and Cap
- Supplied as an assembled replacement part with sufficient grease on guide pins.
- If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins.
- 11 -
Cap
- Removing and Installing, refer to REAR BRAKE CALIPER PISTON .
- Pull onto the piston with the outer sealing lip.