Steering Column Switch Module Assembly Overview

Fig 1: Identifying Steering Column Switch Module, Assembly

Courtesy of AUDI OF AMERICA, LLC

Screw
- 0.4 Nm
Steering Lock Housing
- Removing and installing, refer to STEERING LOCK HOUSING
Ignition/Starter Switch -D-
- Removing and installing, refer to IGNITION SWITCH
Steering Angle Sensor -G85-
- Removing and installing, refer to STEERING ANGLE SENSOR
Transport Protection
- To secure coil connector with slip ring in center position
Coil Connector with Slip Ring
- Removing and installing, refer to AIRBAG SPIRAL SPRING/RETURN SPRING WITH SLIP RING
  CAUTION:
  Risk of damaging coil connector.
  - Coil connector with slip ring is not to be turned following removal.
Turn Signal Switch -E2-
- On vehicles with cruise control, with auxiliary cruise control switch -E45-
- Removing and installing, refer to TURN SIGNAL SWITCH, CRUISE CONTROL SWITCH
Windshield Wiper/Washer Switch -E22-
- Removing and installing, refer to WINDSHIELD WIPER/WASHER SWITCH
Screw for steering lock housing
- Tear off bolt
- Removing and installing, refer to STEERING LOCK HOUSING
Screw for steering lock housing
- Tear off bolt
- Removing and installing, refer to STEERING LOCK HOUSING
Mount
Ignition Switch Key Lock Solenoid -N376-
- On vehicles with automatic transmission
- Removing and installing, refer to IGNITION SWITCH KEY LOCK SOLENOID
Adapter wiring set
- For steering lock housing
- Removing and installing, refer to STEERING LOCK HOUSING ADAPTER WIRING HARNESS
Lock Cylinder
- Removing and installing LOCK CYLINDER
Steering Column Electronic Systems Control Module -J527-
- Removing and installing, refer to STEERING COLUMN ELECTRONIC SYSTEMS CONTROL MODULE
- Pin assignment for steering column electronic systems control module, refer to STEERING COLUMN ELECTRONIC SYSTEMS CONTROL MODULE CONNECTOR ASSIGNMENT .