Knock Sensor 1 -G61-
WARNING: This page is about a different variant/trim than selected.
Removing
-- Remove the electrical connector -2- from the Knock Sensor (KS) 1.
Fig 1: Camshaft Position Sensor G40/Intake Manifold Runner Position Sensor G336, Knock Sensor (KS) 1 G61 & Fuel Injectors 8-Pin Harness Connector Electrical Harness Connectors
-- Remove the coolant pump with the coolant thermostat. Refer to Removal and Installation .
NOTE:
The KS 1 is located below the intake manifold behind the coolant pump.
-- Remove the KS 1.
Installing
-- Install in reverse order of removal.
- Tightening specifications: Ignition system assembly overview, refer to IGNITION SYSTEM OVERVIEW