Camshaft Timing Chain Overview
WARNING: This page is about a different variant/trim than selected.
- Bolt
- 9 Nm
- Chain Tensioner
- Is under tension
- Disconnect the locking pin T40011 before removing
- Timing Chain Tensioning Rail
- Guide Bolt
- 20 Nm
- Bolt
- 9 Nm
- Control Valve
- 35 Nm
- Left thread
- Remove using assembly tool T10352.
- Bolt
- M6: 8 Nm plus an additional 90° turn
- M8: 20 Nm plus an additional 90° turn
- Replace
- Washer
- Bearing Bracket
- Camshaft Timing Chain Guide Rail
- Camshaft Housing
- Camshaft Timing Chain
- Before removing, mark the direction of rotation with paint
- Camshaft Timing Chain Guide Rail
- Guide Bolt
- 20 Nm
- Chain Sprocket
- Crankshaft
- Installed position, refer to Fig 2
- Both surfaces must -arrows- must line up across from each other.