Oil Separator
WARNING: This page is about a different variant/trim than selected.
Removing
-- Remove the noise insulation. Refer to Removal and Installation .
-- Remove the frame for the noise insulation. Refer to Removal and Installation .
-- Remove the bolts -1 through 9- and remove the oil separator.
CAUTION:
Risk of contaminating lubricating system.
- Seal the opening with a clean cloth.
Installing
NOTE:
Always replace gaskets and seals.
Secure all the hose connections with hose clamps appropriate for the model.
Install in reverse order of removal. Note the following:
-- Oil separator tightening sequence, refer to Figure.