SUBFRAME Mount, Checking Adjustment

WARNING: This page is about a different variant/trim than selected.

Procedure

Fig 1: Locating Fuel Supply Line

Courtesy of AUDI OF AMERICA, LLC

-- Release the EVAP canister -B arrow-, remove it upward -A arrow- and lay it aside.

NOTE:

Ignore items -1 and 2-.

-- Check dimensions on the right mount for engine and transmission:

Both bolt heads -2- must be parallel to the edge of the engine mount support arm -3-.

Fig 2: Checking Dimensions At Engine/Transmission Assembly Mounting
Courtesy of AUDI OF AMERICA, LLC
A distance of -x- = 16 mm must be present between engine mount -1- and engine support -4-.

NOTE:

Distance -x- = 16 mm, can also be checked with corresponding round stock.

-- Adjust the subframe if the distance measured is too small or too large. Refer to SUBFRAME MOUNT, ADJUSTING .