Test Drives With The Use Of Test And Measuring Devices
WARNING: This page is about a different variant/trim than selected.
If testing equipment must be used during a road test, observe the following:
WARNING:
Distraction and testing equipment that is not secured properly can cause accidents.
The passenger airbag could pose a risk if it deploys in a collision.
- Operating testing equipment while driving causes it to shift position.
- There is an increased risk of injury due to unsecured testing equipment.
- Position passenger's seat as far back as possible.
- Only use the vehicle diagnosis and service system VAS 5052 A or diagnostic system VAS 5053.
- Testing and measuring instruments -1- must lay flat on the passenger's thighs and be operated by him or her, as shown in the illustration.