Charge Air Cooler Overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
The hose supports, air guide pipes and hoses must be free of oil and grease before installing.
Secure all hose connections with hose clamps of the same type as those equipped by the factory.
To mount the charge hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.
If there are small impressions on the fins. Refer to COOLERS, CONDENSERS AND CHARGE AIR COOLERS .
- Bolt
- 5 Nm
- Mount
- For charge air cooler
- Charge Air Cooler
- Charge Air Pipe
- Assembly of hose connections with connection couplings, refer to AIR GUIDE PIPES AND HOSES WITH CONNECTOR COUPLING
- Bolt
- 10 Nm
- Charge Air Hose
- Assembly of hose connections with connection couplings, refer to AIR GUIDE PIPES AND HOSES WITH CONNECTOR COUPLING
- Hose Clamp
- Charge Air Hose
- To throttle valve control module -J338-
- Hose Clamp
- Bolt
- 10 Nm
- Charge Air Pipe
- Hose Clamp
- Charge Air Hose
- Assembly of hose connections with connection couplings, refer to AIR GUIDE PIPES AND HOSES WITH CONNECTOR COUPLING
- Seal
- Replace
- Charge Air Pressure Sensor -G31-
- Removing and installing, refer to Charge Air Pressure Sensor -G31-
- Bolt
- 5 Nm
- Bolts
- 10 Nm