Fastener Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
| Component | Bolt Size | Nm | ||
|---|---|---|---|---|
| After Run Coolant Pump Bracket to Mounting Bracket Bolt | - | 4 | ||
| After Run Coolant Pump Mounting Bracket to Cylinder Block Bolt | - | 5 | ||
| Connecting Piece | - | 9 | ||
| Coolant Fan, Nut | - | 10 | ||
| Drive Gear for Toothed Belt (1) | - | 10 + 90° | ||
| Fan Shroud, Nut/Bolt | - | 5 | ||
| Front Coolant Pipes | - | 5 | ||
| Radiator | - | 5 | ||
| Small Coolant Pipe | - | 9 | ||
| Toothed Belt Guard | - | 9 | ||
|
||||
Coolant Pump Tightening Sequence
-- Tighten the bolt in the following sequence: -1 to 8-.
- 9 Nm