LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> TT S, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (3.2L - Engine Assembly - Engine Code(S): CBRA (Roadster)) >> 10 Engine Assembly >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
Component Bolt Size Nm
Bracket to Body   20 + 90° (1)
Engine Mount to Body   40 + 90° (1)
Engine Mount to Engine Support   60 + 90° (1)
Engine Support to Engine   45
Pendulum Supports to Subframe   100 + 90° (1)
Pendulum Supports to Transmission   40 + 90° (1)
Bolts/Nuts
  M6 10
  M7 15
  M8 22
  M10 40
  M12 65
Exceptions:
Ground wire   22
(1) Always replace

Manual transmission to engine fastener 

Fig 1: Transmission To Engine Bolts (Transmission Flange Face) Tightening Sequence
GWWA34-10035Courtesy of AUDI OF AMERICA, LLC
Item Bolt Nm
1 1) , 3 M12x55 80
2 2) M12x65 80
4, 5 2) M10x50 40
6 2) M12 x 80 80
A Alignment sleeves for centering
  • 1) Bolt with threaded pin M8.
  • 2) Install in transmission from engine side.

Direct shift automatic transmission to engine mounting 

Fig 2: Identifying Bolts On Engine/Transmission Flange
GWWA37-0650Courtesy of AUDI OF AMERICA, LLC
Item Bolt Nm
1, 3, 6 M12x55 80
5 M12x65 80
7, 8 M10x50 40
9 M10x45 40
10 M12x70 80
A Alignment sleeves for centering
NOTE:

Ignore -2 and 4-.

scientia non olet · About LEMON Manuals