Engine And Manual Transmission, Separating

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Additional Hooks 10 - 222 A /2
Shop Crane VAS 6100
Transmission Lift Hook T40013

Procedure

Engine/transmission assembly is removed and mounted on engine mount.

-- Remove bolts -1- and -2- and remove bevel box bracket -A-.

Fig 1: Bevel Box Bracket & Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Install T40013 at transmission and close locking device.

Fig 2: Engaging Workshop Crane VAS 6100 With Additional Hooks 10-222 A/2 At Lifting Tackle

Courtesy of AUDI OF AMERICA, LLC

-- Engage VAS 6100 with 10 - 222 A /2 on lifting tackle.

-- Remove bolts -1 through 6- on engine/transmission flange.

Fig 3: Transmission To Engine Bolts (Transmission Flange Face) Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove transmission from engine.