Accessory Assembly Bracket

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove ribbed belt. Refer to RIBBED BELT .

-- Remove generator. Refer to [For transmission(s) 02E] Removal and Installation .

-- Remove A/C compressor from engine. Refer to REMOVAL AND INSTALLATION and tie up to body with A/C lines attached.

-- Spray rubber nubs -2 and 4- on after-run coolant pump -V51- retainer -1- with silicone-free lubricating spray.

Fig 1: Identifying Spray Rubber Nubs -2- And -4-

Courtesy of AUDI OF AMERICA, LLC

-- Disengage rubber nubs from retainer -3- for after-run coolant pump -V51-.

NOTE:

Leave after-run coolant pump -V51- with connected coolant hoses on engine.

-- Remove bolts -1 to 5- and remove accessory assembly bracket.

Fig 2: Identifying Accessory Assembly Bracket Bolts & After-Run Coolant Pump V51 Electrical Harness Connector

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore -arrow-.

Installing

Tightening specifications, refer to RIBBED BELT DRIVE COMPONENT OVERVIEW .

Installation is in reverse order of removal, note the following:

-- Tighten accessory assembly bracket bolts. Refer to Figure.

-- Engage nubs -2- and -4- on after-run coolant pump -V51- elastic retainer in bracket -3-.

Fig 3: Identifying Spray Rubber Nubs -2- And -4-

Courtesy of AUDI OF AMERICA, LLC

-- Install A/C compressor. Refer to REMOVAL AND INSTALLATION .

-- Install generator, refer to [For transmission(s) 02E] Removal and Installation .

-- Install ribbed belt. Refer to RIBBED BELT .