Install Camshaft Sprocket

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Camshaft Gear Thin Rib Toward Outside And TDC Marking Visible

Courtesy of AUDI OF AMERICA, LLC

Note installation position: Thin rib on the camshaft gear points outward -arrows- and the TDC marking on cylinder 1 is visible.

-- Install the bolt for camshaft sprocket using the 3036.

Fig 2: Counterholding Camshaft Gear Using 3036 Retainer

Courtesy of AUDI OF AMERICA, LLC

NOTE:

By turning the camshaft, the valves could contact the stationary pistons at TDC. Therefore, the pistons must not be at TDC. Valves/pistons may be damaged.

-- Install toothed belt. Refer to TOOTHED BELT, WITHOUT DIVIDED TOOTHED BELT GUARD .