LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> TT S, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (2.0L - Engine Assembly - Engine Code(S): BPY (Roadster)) >> 10 Engine Assembly >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
Component Bolt Size Nm
Bolts/Nuts
  M6 10
  M8 20
  M10 45
  M12 65
Bracket to Body (1), (2) - 20 + 90°
Bracket to Engine Mount (1), (2) - 20 + 90°
Engine Mount to Body (1), (2) - 40 + 90°
Engine Mount to Engine Support (1), (2) - 60 + 90°
Engine Support to Engine - 45
Exceptions: -  
Pendulum Supports to Transmission (1), (2) - 40 + 90°
Pendulum Supports to Subframe (1), (2) - 100 + 90°
Clamp B+ to Starter - 16
Ground (GND) Cable to Transmission - 23
(1) Always replace
(2) 90° corresponds to a quarter turn.

Engine/Transmission, Fastening 

Fig 1: Identifying Bolts On Engine/Transmission Flange, Removal
GWWA37-0214Courtesy of AUDI OF AMERICA, LLC
Item Bolt Nm
1, 2 M12 X 65 80
3 (1), 4 (1) M12 X 135 80
5 to 7 M10 X 60 40
8 M12 X 90 65
(1) Bolt with threaded pin M8
scientia non olet · About LEMON Manuals