Right Flange Shaft Seat On Outer Bevel Box, Replacing

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Thrust Piece T10049

Procedure

Transmission installed.

-- Remove right flange shaft. Refer to RIGHT FLANGE SHAFT .

-- Pry out the shaft sealing ring for the flange shaft with an assembly lever.

-- Lightly oil outer circumference of new shaft seal.

-- Fill area between sealing lip and dust lip -arrow- halfway with sealing grease G 052 128 A1.

Fig 1: Identifying Oil Seals Sealing Lips

Courtesy of AUDI OF AMERICA, LLC

-- Drive in sealing ring to stop using T10049.

Fig 2: Driving In New Sealing Ring To Stop Using Thrust Piece T10049

Courtesy of AUDI OF AMERICA, LLC

-- Install right flange shaft. Refer to RIGHT FLANGE SHAFT .

-- Check the transmission oil level in the bevel box and replenish. Refer to MANUAL TRANSMISSION, CHECKING GEAR OIL LEVEL .