Left Flange Shaft

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Oil Collecting and Extracting Device V.A.G 1782

Removing

-- Remove left drive axle. Refer to Removal and Installation .

-- Place V.A.G 1782 under transmission.

-- Remove the left flange shaft bolt by installing 2 bolts in the flange and counter holding the flange shaft with the assembly lever.

Fig 1: Identifying Installation Of Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Pull out flange shaft with spring.

Installing

Tightening specification, refer to FLANGE SHAFT AND SEALS ON TRANSMISSION ASSEMBLY OVERVIEW .

Install in reverse order, paying attention to the following:

-- Press flange shaft against spring force and tighten.

-- Install left drive axle. Refer to Removal and Installation .

-- Check the transmission oil level in the manual transmission and fill. Refer to MANUAL TRANSMISSION, CHECKING GEAR OIL LEVEL .