Pulling Outer Race/Tapered Roller Bearing Off Clutch Housing

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

A - Support, for example Kukko 22/2

B - Internal puller 46 to 58 mm, for example Kukko 21/7

-- Tension internal puller -B- between the outer ring for the tapered roller bearing and adjustment shim.

Fig 1: Identifying Outer Race/Tapered Roller Bearing Pulled Off Clutch Housing

Courtesy of AUDI OF AMERICA, LLC

NOTE:

After pulling off, check the adjustment shim for damage and replace if necessary.