Pulling Off Inner Race For Tapered Roller Bearing

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the 40-105 on the differential housing.

Fig 1: Identifying Inner Race/Tapered Roller Bearing

Courtesy of AUDI OF AMERICA, LLC

-- Tension the puller for example Kukko 204/2 in the area of the flattened sides of the differential housing below the inner ring.

NOTE:

When pulling off inner race, make sure that the hooks do not bend outward; if necessary re-tighten bolt -arrow-.

Fig 1: Identifying Inner Race/Tapered Roller Bearing

Courtesy of AUDI OF AMERICA, LLC

A - Extractor, for example Kukko 18/1

B - Separating device 12 to 75 mm, for example Kukko 17/1