Installing The Differential Bevel Gears
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
-- Insert thrust washer union with transmission fluid.
-- Insert both large differential bevel gears and secure (for example with flange shaft).
-- Insert the small differential planetary gears 180° offset and pivot them into position.
-- Press in the differential bevel gear axle -arrow A- up to the first small differential bevel gear.
-- Insert threaded pieces -arrows B- in large differential bevel gears.
- Installed position: shoulder faces the differential bevel gear
-- Drive differential planetary gear axle into final position and secure with spring pin DIFFERENTIAL Roll Pin, Installing .