Adjustment Overview
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When performing repairs on the transmission, readjustment of the output shaft for 1st to 4th gears, output shaft for 5th/6th gear and reverse gear or differential is only required if components, which have a direct influence on transmission adjustment, have been replaced. Refer to the following table to avoid unnecessary adjustments:
| Parts Replaced: | To be Adjusted: | ||
|---|---|---|---|
| Output shaft 1st to 4th gears OUTPUT SHAFT, 1ST TO 4TH GEARS, ADJUSTING | Output shaft for 5th/6th gear and reverse gear OUTPUT SHAFT FOR 5TH/6TH GEAR AND REVERSE GEAR, ADJUSTING | Differential DIFFERENTIAL, ADJUSTING | |
| Transmission housing | x | x | x |
| Clutch housing | x | x | x |
| Output Shaft, 1st to 4th Gears | x | ||
| Output Shaft, 5th, 6th and Reverse Gears | x | ||
| Differential housing | x | ||
| Tapered roller bearing for output shaft for 1st to 4th gears | x | ||
| Tapered roller bearing for output shaft for 5th/6th and reverse gears | x | ||
| Differential tapered roller bearing | x | ||