Fan Shroud

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Hose Clip Pliers V.A.G 1921

Removing

-- Remove the bolts -1- from above.

Fig 1: Fan Shroud Bolts And Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove center noise insulation fasteners -1 to 4-.

Fig 2: Center Noise Insulation Fasteners And Center Noise Insulation Panel

Courtesy of AUDI OF AMERICA, LLC

-- Remove the air duct -1 and 2- for charge air cooler.

Fig 3: Air Cooler Air Duct

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

Fig 4: Fan Shroud Bolts And Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolts -3- and remove the fan shroud downward and off.

Installing

Install in reverse order of removal. Note the following:

For the correct tightening specifications, refer to RADIATOR AND COOLANT FAN OVERVIEW

-- Air guide pipes with connector, installing. Refer to HOSE CONNECTIONS WITH CONNECTOR COUPLINGS, ASSEMBLING .