Pendulum Support

WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Proceed as follows:

-- Remove noise insulation in center by loosening fasteners -1 through 4-.

Fig 1: Center Noise Insulation Fasteners And Center Noise Insulation Panel

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolts -1 through 3- and remove pendulum support.

Fig 2: Identifying Pendulum Support & Bolts

Courtesy of AUDI OF AMERICA, LLC

Installing

Tightening specifications, refer to SUBFRAME MOUNT ASSEMBLY OVERVIEW .

Installation is in reverse order of removal, note the following:

-- First tighten pendulum support on transmission -arrow B- and -arrow C- and then on subframe -arrow A-.

Fig 3: Identifying Pendulum Supports Installed With New Bolts

Courtesy of AUDI OF AMERICA, LLC