Transmission Side SUBFRAME Mount Tightening Sequence
WARNING: This page is about a different car, the 2009 Audi TT and 2008 Audi TT. However, it is still accessible from the selected car via links, so may be relevant.
-- Insert transmission plate -A- between transmission and transmission mount support arm.
-- Tighten transmission plate on transmission.
-- Raise transmission to transmission mount support arm with Engine Support bridge 10 - 222 A spindle.
-- Next, install bolts -2-, but only hand tight.
CAUTION:
Risk of damaging threads in transmission mount support arm due to bolts inserted crooked.
- Before installing bolts -2-, transmission plate and transmission mount support arm must be absolutely parallel to each other. If necessary, raise rear of transmission with trolley jack.
-- Only tighten bolts if subframe is installed and subframe mounts are adjusted. Refer to Description and Operation and refer to [For engine(s) CETA, CCTA] Diagnosis and Testing or refer to [For engine(s) CDMA] Diagnosis and Testing or refer to [For engine(s) CBRA] Diagnosis and Testing or refer to [For engine(s) BPY] Diagnosis and Testing .