Removal And Installation: Radiator
Removing
NOTE:
When assembled correctly, radiator and condenser can show slight impressions on the fins. It is not damage. Radiators or condensers should not be replaced because of slight impressions like these.
-- Drain the coolant. Refer to COOLING SYSTEM, DRAINING AND FILLING .
-- Remove fan shroud. Refer to FAN SHROUD .
-- Remove the upper coolant hose -arrow- from the radiator by removing the retaining clip.
-- Remove the bolts -arrows- on the rear side of the radiator.
-- Lift radiator slightly and remove upward and off.
Installing
- Tightening specifications, refer to RADIATOR AND COOLANT FAN OVERVIEW .
Installation is done in reverse order, observe the following:
-- Install fan shroud FAN SHROUD .
-- Fill with coolant. Refer to COOLING SYSTEM, DRAINING AND FILLING .