Fastener Tightening Specifications
WARNING: This page is about a different variant/trim than selected.
| Components | Fastener Size | Nm |
|---|---|---|
| All Wheel Drive Control Module to Rear Final Drive | - | 6 |
| Buffer to Rear Final Drive1 | - | 60 + 90° |
| Cover for Oil Filter | - | 35 |
| Crossmember to Underbody | - | 23 |
| Drain Plug for Haldex Clutch Pump | - | 30 |
| Driveshaft to the Bevel Box | - | 60 |
| Flange to Driveshaft, Nut | - | 210 |
| Flange to Rear Driveshaft Tube | - | 45 |
| Flexible Disc with a Heat Shield to Front Driveshaft Tube1 | - | 50 + 90° |
| Flexible Disc with a Heat Shield to Manual Transmission with Bevel Box | - | 60 |
| Flexible Disc with Vibration Damper to Rear Driveshaft Tube | ||
| -Balance Nut | - | 10 |
| -Bolt1 | - | 50 + 90° |
| Flexible Disc with Vibration Damper to Rear Final Drive | - | 60 |
| Front Flexible Disc1 | - | 50 + 90° |
| Haldex Clutch Housing | - | 50 |
| Haldex Clutch Pump to Haldex Clutch Housing | - | 6 |
| Haldex Clutch to Rear Final Drive | - | 50 |
| Intermediate Bearing Heat Shield | - | 25 |
| Lock Plate to CV Joint Protective Boot | - | 40 |
| Manual Transmission with Bevel Gear Transfer Case1 | - | 50 + 90° |
| Oil Filler Plug | M10 x 1 | 15 |
| Oil Filler Plug | M20 x 1 | 40 |
|
||
-- Tighten pendulum support first to transmission -arrows B and C- and then to subframe -arrow A-.
| Component | Nm | |
|---|---|---|
| On the pendulum support | Transmission -arrows B and C- | 40 Nm + 90° 1) |
| Subframe -arrow A- | 100 Nm + 90° 1) | |
| 1) Replace Bolts | ||
-- Tighten the pendulum support with new bolts. For the correct tightening specifications refer to Specifications .
| Component | Nm | |
|---|---|---|
| On the pendulum support | Transmission - 1 - | 40 Nm + 90° 1) |
| Transmission - 2 - | 40 Nm + 90° 1) | |
| 1) Replace Bolts | ||